Ok just thought I'd share my experience trying this. I built a 4S3P out of real Panasonic 18650 3400mah batteries for use on the hexa (really just to play). Well did not go so well. My two Turnigy 5000 mah managed to keep the 680 Pro up for 20 minute
Ok I built a 4s3p battery using Panasonic 18650 / 3400 mah batteries. I placed a PCB board wired with one balance lead. I get current from battery side but not out P+/P-. The directions said if 0v out P+/P- then apply voltage to activate chip. I trie
Hope this works posting from my cell.My 680 Pro is almost ready for maiden flight but one problem only 4 motors spinning. APM 2.6 3.2.1 flash, flashed with HEXA flash. Works fine if I hook each to ch 3 and spin them. Any thoughts?