I have been trying to setup a Tarot Gimbal on a APM 2.6 running 3.2 following the directions at http://copter.ardupilot.com/wiki/common-tarot-gimbal/. I can get tilt to work on RC10 and RC11 but not RC9. I think RC9 is for a relay on APM 2.6, d
Read more…Does any anyone know size and source for replacement bearings for 3DR AC2836-358, 880Kv motors?
Read more…I have a issue on a Quad with 20amp 3DR ESC (non simonK) and 28-36 750KV motors. I have never had a issue in flight (50+) flights. However very freqently one of the motor (not alway the same one) will cut out/stop while spinging up at low spee
Read more…Want to sell 3DR Hexa Frame and QUADframe 155mm Extended Landing Legs and GoPro Gimbal . Never flown. Pictures attached. Please PM offer. Paypal preferred. I will mail these inside US for free, outside US you pay shipping.
Read more…I have a set of 6 AC2836-358, 880Kv motors. Includes prop adapters. Installed and bench tested, never flown. Pictures attached. Please PM offer. Paypal preferred. I will mail these inside US for free, outside US you pay shipping.
Read more…I am new and trying to learn to understand logs. Quad pitched to one side and crashed while rotating/yaw. Seems like it was just not able to react quck enough? Low pid? Any thought or advice on how to interpret log and correct?
Read more…Why is my time messed up in my logs. See time stamp and slips in GPS Timems? Just want a easy way to get total time in flight...
Read more…My new APM 2.5 with ArduCopter V2.9.1b connects to Mission Planner and downloads MAV data. HUD/Status does not update. Most test in terminal run, except setup|accel and test|ins fail, they halt/hang after Init Gyro. I assume this is a hardware
Read more…