I am try to get my JDrones IO board to read Mavlink Messges which was possible a few years ago. At the moment I can read the Mavlink messages from a Pixhawk 2 and arducopter 3.5 RC1 using an arduino mega.Unfortunately when a compile the code for a Pr
Read more…I would be grateful if someone could explain the sudden spike in RCOUT near the end of the flight on all motors
Log file included
Thanks
David Ardis
Read more…I have minimosd extra plugged into Telem 2 on the pixhawk everything is working apart from the number of satellite and GPS lock only appears when the copter is armed. Everything works if i plug the osd into Telem 1
The setting below are what I am usin
Read more…Does anyone see a problem with using an XT90 Anti Spark connector in a X8 with as 6 cell power supply. My concern is doing damage to the Pixhawk and RC with the initial connection through the resistor.
Thanks
David Ardis
Read more…I am in the process of setting up a X8 Skyhero 850 with Pixhawk flight controller. when doing straight waypoint missions there is a sharp twitch at each waypoint.
After a few waypoint flights yesterday I was thinking the Pitch and Roll I setting was t
Read more…I have just finished a TBS Style Frame with APM 2.6 and arducopter 3.0.1. Which is flying well but has a strange problem when a rotate clockwise a few times and stop quickly it will lift the back right then level out. If i rotate counter clockwise a
Read more…Just got an APM 2.6 which I cant get working with a futaba 2.4ghz receiver. The APM works with up to 3 channels connected to the receiver when I connect channel 4 the APM locks up. I have three receivers and get the same problem with them all. I also
Read more…I have been having a problem with my hex in auto it appears to be switching between Auto, RTL, Loiter and Stabilize modes at random when in Auto mode (Last log file enclosed)
The strange thing is the first flight was perfect took off did mission and l
Read more…I have got a 3DR Hex and APM 2.5 by default the loiter radius is 5m can this be reduced ,is it a good and I so how low can it go
David Ardis
Read more…I have a APM Ver 1 which I recently installed into a 3DR Hex frame. I have a problem getting channel 6 to work. When I calibrate the radio channel 6 does not work if I unplug ch6 from the receiver and plug it in again it works until the radio is swit
Read more…I have an Ardupilot mega with a Locosys GPS module. I have have gone through all the steps in Chris Anderson's tutorial setting the GPS to a baudrate of 38400 and all working in realterminal.
I am unable to get the GPS to work with Ardupilot Mega. I
Read more…