I know someone two people that today will be taking their BNUCs flight exams today 1 of these people has never had any interest in anything technical and never picked up a transmitter, and has had maybe a week of practice using a DJI Phantom and an S
I have been trying to get the autoland feature working for a couple of weeks now to no avail? The first time I made a flight plan with several waypoints and then a final LAND command where the plane would reach and then stall, on the second attempt I
I just installed an airspeed sensor on my new APM 2.5.. I have enabled it in mission planner and it seems to be workig well? But when I click on enable airspeed the horizon pitches up and down depending on the airspeed reading, so if I blow
I have been trying to get a bluetooth link working with my APM2 to avoid constantly plugging and unplugging the usb in whilst tuning, I know this can be done, but it is proving irritating? i can change baud rates e.t.c and plug the module into the te
Has anybody had good results from using auto mode in conjuction with the mission planner?
and what pid`s are you using? it appears to me that there are a vast range of PID`s being used for auto mode, where as some of the other fuctions such as loiter
I have just been testing my GPS as it takes me ten minutes to get a 3d fix? so I decided to see what is going on, and yes it takes ten minutes still, but it indicates a 3d fix and sat count 3? this I thought is impossible? you need at least 4 sats fo
I have just been flying my tricopter in 20 to 29 mph winds and found it a bit of a handful, now some of you may think "of course" but this was not the case with a kk board? whilst it was still no easy task it was much easier, I think it is because th
When I have USB connected and go into flight planner under the status tab, nearly all of the data is floating around i.e increasing and decreasing by an amount with the craft laying still on the floor, is this normal?