Hello,
Hello,
I would require some help in order to set a system that i need.My hardware is the odroid xu3 board , huawei e1750 gsm modem and the pixhawk autopilot board with px4 fligh stack.The basic idea is to forward all the information from the pixhawk t
Hello,
I want to activate a servo for deploying the parachute whenever i go on failsafe.
Do you know how can i set a failsafe on px4 with qgroundcontrol.I found a widget that seems to be used for activating the failsafe but it doesnt seem to respond to
Read more…Hello im currenlty trying to make some servos work with the ixhawk autopiot.It seems tht everythig is connected correctly and the servos are getting powered as well.
i have the ESC connected ot the servo raila nd two servos connected to the main outp
Read more…Hello i get this error message while im trying to start a simulation in Qgroundcontrol with pixhawk.The message is "EKF stale sensor data".
Anybody knows to what this error refers to?
Thanks.
Read more…Hi!
I have currently bought an APM 2.6 board and intend to use it for Hardware-In-The-Loop simulations in X-Plane 10. However, when I flash the ArduPlane firmware I get a message from mission planner telling me "bad gyro health" and the sensors seem n
Read more…Hello im using pixhawk and qgroundcontrol in order to create an auto mission with waypoints.
After i succed with running one auto mission the next time i try to start a new one i get an error in ground control . The message is : "Critical in Air mode
Read more…