Hello everyone and Helllllllllllppppp me !!!!!,
On both my quad , I have installed version 3.1 and they are very "soft" power , I increased the value trottle_max to 2000 to find a slightly correct reactivity , but it is not viable , it also has a deri
Read more…since I updated the firmware compatible with MAV10, I systematically to boot the message "Update CharSet". I have to do a reset to miniOSD, to boot properly. I works with APM2
Has anybody a solution?
Hello,
After having built a quad that works very well in v2.1 and so I decide to build a hexacopter.
I need help because I do not understand the reaction of my hexacopter and above all the way to find a solution.
It has a permanent YAW on the right
Hello,
I have a big problem with the mode Alt_Hold with my two quad. It has all the XL-2 MB1200-EZ0 MaxSonar.
Dice the transition mode Alt Hold the quad does not maintain properaltitude. They have enormous oscillations up to two meters.
If someone has a
Hello,
I'm running version 2.0.39b and I connected on port 6 of oilpan to make a Stabilization of the camera.
Alas it is not working, that there is a procedure for turning on this feature?
Thank you in advance for your help
John
nice crash today, after testing on the left YAW. the bird has returned toitself and of course finally the ground. No problem if I use the right YAW.
If anyone has an idea, I go back to see if the glue is ready;-)
john
Read more…hello,
I set up 3x 3.9 KOhm resistor, but APM Planner received 4 volts for 3 cells or battery voltage :-(.
I checked the battery connection on the card and it is:
black GND
yellow AN0
blue AN1
red AN2
If someone have a solution ?
john
Hi,Someone can tell me the differents or advantage with this two setup + and X ?
Read more…