Hi,
I'm running Megaplanner on kubuntu 13.04.
Everything seems to go fine on startup. However I'm not able to use my telemetry because the arrow on the drop down box for choosing the baud rate is not available.
There is a white rectangle over the place
Read more…A while ago I had a bad crash (prop failure), and now my copter is not loitering properly anymore.
What happens is that it initially does fine for a few tens of seconds and then it starts circling with ever increasing speed.
When I calibrate the compas
Read more…I had a lot of trouble getting mission planner to run correctly on my linux 64bit debian sid system.
After lots of fiddling and tweaking I found installing ONLY mono-runtime and libmono-winforms2.0-cil makes mission planner run fine.
So for those of y
Read more…In more recent versions of the mission planner there are two ways of entering PID values, one is the 'arducopter config' tab that is more or less the same as the older versions, and then there is the 'Arducopter pids' that seems like an attempt pres
Read more…In more recent versions of the mission planner there are two ways of entering PID values, one is the 'arducopter config' tab that is more or less the same as the older versions, and then there is the 'Arducopter pids' that seems like an attempt pres
Read more…Hi,
I'm trying to run mission planner on linux (debian). However when I startup I get a lot of errormessages (see attachement).
I think I am missing some required mono library/package, but I don't know which. Is there some list of requiered depencies?
Read more…Hi all,
Today I was flying my copter (GAUI 330/APM1/v.2.5.5 from MP) and suddenly it made a very strange flip/roll. Luckily I had some height and the copter stabilised after e few seconds but this was quite scary. Before and after this moment everythi
Read more…Hello,
Is there a way to find out the exact version of the firmware that Mission Planner installs? I would like to be able to reproduce the exact version that is installed by mission planner (including used configuration files etc.) in arduino.
On a re
Read more…Hi,
My quad (stock GAUI 330 + arducopter 2.1.0 from APM) is circling in loiter mode. From what I read in this forum and the wiki this may me caused by a wrong compass inclination.
If I take my copter outside with mission plannner connected and wait fo
Read more…Hello,
I'm getting a little bit confused about Arducopter software versions.
According to the wiki one should download code using the mission planner.
As of today (v.1.1.19) the software that it uploads is called '2.1.0 Alpha'
However, when I go to the
Read more…Hi,I've encountered a problem with the 2.0.42 software when used with a tricopter.It seems that the yaw input direction is reversed with respect to the stabilisation control direction. I can fix it by patching the code (see below) but I'm wondering w
Read more…Hi,
Is there a way to upload the the frimware from apm without an active internet connection? I cannot access the internet at the location of the copter.
Yours,
Gerrit Jan
Read more…Hi,
I'm having problems getting the arducopter 2.0.38 software working through the arduino IDE. I'm tring to fix some camera issues (wrong direction and scaling) and this requires recompiling the code.
I used information from http://code.google.com/p
Read more…