I have a 3dr quad frame that I added longer arms to account for the 12" props and dji e600 motors I upgraded and I just have not been happy with its performance. Looking for a frame that is symmetrical and can hold the pixhawk, power dist board, gps
Read more…Had no problems with 2.0.14 and can connect via the usb port without problems as well. Not sure why the new release is causing problems.
Any suggestions?
Read more…Anyone have longer arms they have used for the 2014 diy 3dr frame. These dji 12" props will be to big and that is what I will be required to use with the motors I have(e600).
Hoping someone designed some newer arms that also have more screws hole t
Read more…I have been reading you do not need to calibrate dji opto escs and after installing cannot get them to work properly.
I am trying e600 escs which plug directly into the power distribution board.
I did try to do a calibration after it failed to work and
Read more…This is a bit of a cry for help because I have tried everything I can possibly think of and still not having any luck to get my drone in the air.
The problem is that I can get all the motors to spin in sync in calibration mode but as soon as I unplug
Read more…Does the dji f450 kit easily work with the pixhawk hardware when connecting to the dji power distribution board? Do you need individual BECs for the dji escs?
How much easier does the 3dr power distribution board make the building process.
Any advice
Read more…I am in the process of buying components for my quad and I would like to know if I need the ppm encoder to go from the ar8000 to pixhawk?
Any reference pictures how other did this would really help me see the best method.
Will be using a Spectrum D
Read more…