Johar Palacita's Posts (1)

Sort by

ArduRover Skid Steering

Hi, I'm building ArduRover with Skid Steering, The platform are base of DFROBOT Pirate 4WD and using 2 DC Motor L298N

8997855656?profile=RESIZE_710x

 

I'm using the firmare for Pixhawk 1 (fmuv3)

4.0.0-FIRMWARE_VERSION_TYPE_OFFICIAL

and according the ardupilot docs for Rover
My config for CH1 and CH 3 are

For “Skid steering” vehicles (like R2D2) these parameters values will need to be set:

Actualy its depend on your wiring setup at L298N for direction

8997883685?profile=RESIZE_710x

Here is the schematic of how I wiring it.

8997885267?profile=RESIZE_710x

The ENA and ENB jumper was remove.

For skid-steering vehicles like the Pirate 4WD from DFROBOT
Set MOT_PWM_TYPE = 3

8997896266?profile=RESIZE_710x

In my transmitter when throttle is zero the the ch1 push left a quarter, it will rotate the rover to left (left wheel stop - right wheel move) and also the opposite. But if push full it will move fast forward.

If the ch 3 push half more (55%) it will move forward slowly. I'm still setup some parameters for smooth moving.

 

Read more…