Hugin UAV. I think it has everything except the main gear. No electronics. Product Page; https://www.fpvmodel.com/remote-control-electric-powered-new-hugin-2-2m-v-tail-h-tail-glider-rc-airplane-power-combo-selectable-_g43.html
$200 plus shipping from
Hey Guys, I am playing with a Wild Thumper 6x6 setup as an ArduRover. I am not so much interested in it being setup for autonomous usage but want to tune the manual operation. Is there a mode or setting I can adjust so that it has heading hold when d
Read more…So I am about to try using AutoTune but want to make sure I know which position the switch should be in. It is only explained as "Put your switch in the High position to engage auto tuning". Can someone advise approx what value I should be seeing in
Read more…So I have been struggling with 2 issues with my APM on an X8.
1. After recently resetting to defaults and starting over, the APM will not remember my radio calibration. Regardless of how many times I try, it says it has completed but when I try to arm
Read more…APM 2.0 with latest firmware, using PPM from a Futaba FASST system.
So I was having some strange issue (turned out to be my own fault, swapped motor outputs, been fixed) and decided to reset everything to default. Everything is working fine now except
Read more…I am going to build a rover/car robot with onboard camera that is connected to my network via wifi.
Here is what I have planned;
Onboard PC (running XP on an SD based drive with usb based video capture and wifi) with a servo controller for all actio
I have an Xbee explorer board connected to a Mikrokopter board to xmit telemetry info to another XBee connected to my laptop. The link works great, never had an issue. I just added a EPI OSD onboard that connects to the same din/dout as the XBee but
Read more…