Hello friends,
First of all, I don't really know in which category could be assigned this post, if you do so, please tell me and I'll modify it.
So, I'm planning to send a payload to nearspace with a Helium balloon. All powered with an APM sending tele
Hello, This evening I crashed my hexa. :( First of all, I want to say that the main problem was the remaining battery...
I wanted to reach 200m but I forgot that the Fence FailSafe was enabled at 100m, so I though I lost control of the copter when it
Hello, yesterday I crashed my hexacopter :'( It was flying perfect all the morning but suddenly at 13:24 it was flying at 10-15 meters high and it rolled to the left and falled with no control.
It is destroyed as you can see in the picture, lucky it
Hello, I've just installed my new gimbal (This one) and it works great! But I'm trying to add the Ch_6 function to control the tilt. It works great but only in +-30º if I pass those angles it starts to shake and goes crazy... It works great if I pass
Read more…Hello, I've been experiencing some problems with Mission Planner, and I think I could be not the only one...
There are some parameters that always appears in yellow, even if the param listed in the full param list is in the correct range...
I'm having
Read more…Hello! I've working in my Hexa since 6 months ago and it is flying since 1 month from now.
I have just one question... How much time your flight long? I am flying with a 5000mAh 4S and a can not reach 10 minutes of flight...
This is my stuff:
- Hobb
Read more…Hello, I'm having some problems trying to connect the APM trought the USB port. It had been working fine, but today I can't do it... It connects trought the 3DR Radio (PORT 6) but with the USB cable only the terminal tab connects and I can do all the
Read more…Hello, I already have a GoPro and a Gimbal working on my Hexacopter. Now, I'm looking for a good camera for FPV. I don't need an expensive camera, just a good one to see where I am and what I'm filming with my GoPro... Right now I have a Boscam 5.8Gh
Read more…Hello, I'm trying to make works some strobe leds on my Hexacopter plug them into the A7 pin...
I would like the leds to be off when not armed and blink when armed so I need the pin A7 to be 0 (NO BLINK) when not armed, and 1 when armed...
I've never wo
Hello, I burnt my 3DR power module due to a wrong connection... :(
The yellow component installed in the center of the board, and looking at the Eagle Schematics, the one which do all the calculations of intensity, is dust...
I just ordered a new one,
Read more…