Hello,
First if this is posted in the wrong place feel free to redirect me to a better forum.
I've been following this tutorial. I've got a FTDI cable connected as described (without the +5v connected) and that seems to be working. I've set the baud
Read more…My power module doesn't seem to be providing 5 volts any longer. While I'm waiting for a new power module could I power the entire APM with my BEC by installing JP1 without hurting anything?
Thanks,
Loren
Read more…Well it was bound to happen. Here is the clip:
https://www.youtube.com/watch?v=hpE-dyNMmQA
My question is now what?? Narrowing it down a bit I guess is what values in the log should I look at to find out what caused it to flip like it did?
Read more…I have my quad put together and a couple of folks suggested some changes in my wiring scheme to eliminate the possibility of harming the APM.
The comment that I had been following can be found here as well as the post following it. I have removed a
Read more…Hi,
Attached are a few photos of my first setup. I'm curious what I might be able to layout a little better. I have my distro mounted directly to the X525 top plate. Above that is a piece of plexi with my rx stuck down. Above that is a shock mount
Read more…Hello everyone!
I've been a long time lurker and finally have a ardupilot 2.6. I have succesfully connected it to Mission planner (v1.2.62). When I attempt to calibrate the compass I get an error that says "log does not contain enough data" Can som
Read more…Hello,
I've been going through the ardupilot code to try and have a better understanding of how a multicopter works. Along with this info I think I have a basic idea of how an auto pilot works. This is my understanding at this moment:
Am I close wit
Read more…