"Hi @Jose,
I had a VERY similar problem to you last week. Especially with the difference between the aircraft having a very aggressive right-hand turn and a very slow left-hand turn. I posted about it here.
The problem ended up being that I had a…"
"Hi everyone,
I flew my skywalker again yesterday, and it turned out a reversed rudder was indeed the problem. I didn't pick it up in my preflight checklist as my rc controller was moving the rudder in the correct direction. It seems that the rudder…"
Hi Everyone,I've recently installed a pixhawk running Plane 3.4 into a 2015 Skywalker 1830. The plane flies pretty nicely in Manual and FBWA modes but there seems to be an imbalance in the aggressiveness of left and right turns in AUTO mode. When…
Hi Everyone.Apologies if this has already been asked before, but I have been trying to attempt an autonomous landing with an APM 2.5 in a Skywalker. The aircraft navigates perfectly fine all the way up until the aircraft aims for the landing…
Hi everyone,Apologies if this has already been addressed somewhere in this forum already, but is anybody aware of a freeware simulator that can be used for HIL simulations for Ardurover in the same way that FlightGear can be used for…
Hi Everyone.Would anyone have a parameter file tuned for a HIL simulation using FlightGear. I've managed to get the quad behaving nicely in stabilize mode but my altitude hold in auto (or alt hold) is terrible.Thanks guys.Luke
"Thanks for your reply Kate.
I followed your instructions, and everything seems to work fine until I finish uploading the firmware. You're document says that after the firmware is uploaded the “A” LED should turn green. My "A" LED flashes red. Does…"
Hi Everyone,I'm quite new to using Arducopter and I am trying to set up a hardware in the loop (HIL) simulation using an APM 2.0 board, Mission Planner and FlightGear. I have followed the instructions to set up the APM 2.0 board into HIL mode…