Andropilot vs. Droidplanner
What do you recommend to use? Id like to find a comparison in terms of reliability (does it crash often?) and usability (interface, functions). Thanks alot!
Read more…Michal Rusina's Discussions (14)
Sort by
where can i find apm planner with mavlink 1.0?
there is a mention about it in lates version of arducopter, but i cant find it in the download section at arducopter nor arduplane...
Read more…MTK16 GPS not working on APM1280
after update to l2.5.4 code on my apm1280 with disabled cli logging and gps set to MTK16 (not AUTO) the gps stopped working. status led on gps is on, but the gcs says "no gps" and loiter is not working. after compiling with auto, everything is ok. if
Read more…joystick/gamepad feature request
hi, few ideas for gamepad control from missionplanner
1. use gamepad for camera control so i can use RC for flying and gamepad for advanced camera control (pan, tilt, zoom, focus, shutter, ...) there is enough controls on the gamepad for all.
2. use 4w
Read more…Why is CH_7 on defined as > 800
My tx generates pulses approx. from 1000 to 1900, so i cant use it as a switch, is that true?
Read more…2.0.47 - missing relay_on?
i get this error on 2.0.47 when trying to compile with running lights. before that it worked without any problems... any help?
Read more…Troubleshooting "After aggressive flying my copter leans to one side 10 - 30°"
this sentence means that it yaws to one side or rolls/pitches on one side?
Read more…yaw after takeoff
my copter turns a little bit to left after takeoff. i found this in the wiki: "My copter spins right or left 15° when I take off: Your Motors are not straight or your ESCs are not calibrated. Twist the motors until they are straight. Run the ESC cali
Read more…Bad Gyro
sw: latest mission planner
fw: latest (uploaded via missionplanner), also tested with 2.0.8 and a few more
hw: macbook, apm1280, oilpan, mtek gps, magneto (everything from diydrones), turnigy plush 18a, 2200mah lipo
homebrew quad (x), m2m 50cm, 10x4.7
gsm/gprs/edge for telemetry
has anyone tried something like that? i can imagine a lot using this to communicate, in eu we have fairly cheap unlimited data plans and it would be possible to transmit video and telemetry with almost unlimited range (considering a small time lag) w
Read more…Still cant connect via USB, but CLI is working.
After updating the Mission Planner and firmware to AC 2.0.2, still cant connect in the fly mode or "test sensors" mode (switch away from pin headers). Everything else is working (code upload, cli tests and setup). any hints what could be wrong? (hw/s
Read more…cannot arm motors
hi. i uploaded the code via mp, tried to test it via mp and into the same issue as in
http://diydrones.com/forum/topics/arducopter2-trouble-connecting?id=705844%3ATopic%3A362863&page=1
but i have the gps connected properly... then tested everything
Read more…ArduPilotMissionPlanner vs. ArduCopter - missing possibility to upload firmware
Hi. As i understand the latest ArduPilot Mission Planner should have the possibility to upload ArduCopter firmware. I tried it but there are only options for ArduPilot. I tried to upload the code using arduino but it returned a lot of errors. Can any
Read more…