Hi, need help of pairing the Pixhawk with Optima 9 receiver. Already success the firmware upgrade (v3.01) via HP-22 for both receiver and 2.4 module as per the wiki below:
http://copter.ardupilot.com/wiki/common-pixhawk-and-px4-compatible-rc-transmi
Read more…Crashed my Quad yesterday at the height of 35ft due to battery failure. It fell horizontally and the impact caused the top carrier which carry the Ublox gps came off forcing it to pulled the cable and dislodge the gps port located at the bottom carri
Read more…https://www.youtube.com/watch?v=rAs0-IU4PrU
Sharing my APM 2.5 performing Loiter 360 panoramic aerial video without gimbals and image stabiliser apply.Recorded on gopro 1080hd then converted to 720 for faster upload.Fr my opinion this board is really s
Read more…I tried the AUTO mode on APM2.5 and load my Quad with firmware 2.7.3 and then created 6 points for a start.1st to 4th point it when well when it reached 5 point the copter slowly decend itself even though the altitude set was 10m. Forced me to switc
Read more…Hi, my CIRCLE mode turn out to be a bit jerky and wobbly and i have no idea where to tune. Its a multi- cool mode and I like it. Thanks to the developers. Should i tune the ROLL or YAW? Anyone having the same issue. Need some tips here guys. Below is
Read more…Is it possible for the APM to perform Orbit Mode like the AutoQuad. I found it really useful especially for AP/Video to do a 360 around the point of interest while keeping camera pointed to it. Is there any source code for it?
Read more…I found out that Arducopter Mega Mission Planner 1.8.3 'Auto Trim' Ch7 function really useful. 1) Fly 2) Hover your copter till its really stable (ensure all the Tx trims in the mid position) Switch Ch 7 Auto Trim ON and flick it back OFF. Observe th
Read more…Hi to all,
This is for a start discussion. I'm still working on the three modes to successfully follow the command.
So far its oscillate too much although the altitude hold worked well with barometer when i engaged @ 25ft height. Any way to make all th
Read more…