Gender
Male
About
Please tell us a bit about your UAV interest
I use my drone for photos etc. And of course it's fun :)
Hometown:
Borlänge
Activity Feed
"Perhaps the GPS module have a specific baudrate that not match the mainboard, and will be corrected with a fresch config-file? I shall try to connect the GPS-compass module and see if I have the same fault.
I don't understand why Walkera does not…"
I don't understand why Walkera does not…"
"Amazing!
I loaded the QR X350 configfile and then loaded the Tali H500 paramfile in Mission Planner. It seems to STORE the new value at last! I did this by remote from my work via Teamviewer so I have to "power off" the mainboard from USB when I…"
I loaded the QR X350 configfile and then loaded the Tali H500 paramfile in Mission Planner. It seems to STORE the new value at last! I did this by remote from my work via Teamviewer so I have to "power off" the mainboard from USB when I…"
"Thanks for your reply! I haven't find any solution yet. Can you please give me the link where you found the QR X350 issue? Maybe I can ask them for a solution."
Hi. Does anybody know how to save the param-file via Mission Planner? I'v opened the param file in Full parameter list, write params and refresh params to see that the new values was written. But after power off an reconnect the old values is back.…
