On new APM1 system, the instructions went smooth up to setup -radio check. No variable bars. on exit all 6CH read 0=min 3000= max. Latest AMP, new hardware, arduplane software. functional Tx. Servos follow the stick OK!. Modes switch OK, params lo
Read more…In using the Mission Planner (Ver 10) to upload the A/C specific configuration (easystar.param).via the AMP a dialogue window opens with the title "SAVED NOTE" with the message "4:22:48 PM Easy Star Post Crash"
The OFP (firmware) loads ok with the gen
Read more…The form fitting cockpit electronics rack kit includes 8 Nd-60 magnets to secure the rack to the Easystar foam cockpit cavity. Slick. About to install the magnetometer option to improve heading information.
This puts the magnetometer sensor 3cm from
Read more…Hi
While waiting for an assembled A/P Mega to arrive, I downloaded and extracted the APM software - opened it and searched on but could not find the directed ArdupilotMegaPlanner.exe file. I did find a file named ArdupilotMegaPlanner.exe.config but
Read more…The title says it all. Which of the two shield mounted air pressure sensor ports is to be tubed to the static pressure tube? The A/C testbed is a very slow flying foamy - 12x8 prop geared down to 6:1. Trial and error results are indeterminate poss
Read more…novice level - latest H/W and S/W. Anyone have knowledge of the following behavior?
I finshed A/P IMU and Airframe integration Fine . Good response to Tx control inputs.
Tried to reload software. The IMU reload was OK.
The standalone reload of the A/P
Read more…I am sure many people have done the Ardu/Pilot\Shield integration with the Ardu IMU V2. I have come to a halt and would appreciate some pointers to get restarted.
1 If the single Y cable supplied with the shield are to be used with the V2 IMU, where c
Read more…