Gender
Male
About
Location
Shah Alam
About Me:
amateur APM
Please tell us a bit about your UAV interest
multirotor system microcontroller
Hometown:
Malaysia
Activity Feed
"Hattori san,
Thank you very much, i have browsed to the the mentioned website. It is great to know that the company has wide range of choice for RC Hobbyist.
I will pay a visit in this weekend. "
Thank you very much, i have browsed to the the mentioned website. It is great to know that the company has wide range of choice for RC Hobbyist.
I will pay a visit in this weekend. "
"Thank you very much Randy.
Nice to meet you too.
Yes i do agree with you, safety first. It is not right to fly around without considering the failsafe. I have tuned the failsafe last week, and performed flight testing at the nearby football field…"
Nice to meet you too.
Yes i do agree with you, safety first. It is not right to fly around without considering the failsafe. I have tuned the failsafe last week, and performed flight testing at the nearby football field…"
"I am currently using the following setup;
1-TBS Discovery Frame kit with APM 2.6
2-FPV gear, Fatshark Predator V2 Vision System
3-Bullet Proof ESC, 900kv Tiger Motors, Graupner 9X5 Propellers
4-4500Mah 4S battery
5-Turnigy 9XR with Frsky Module…"
1-TBS Discovery Frame kit with APM 2.6
2-FPV gear, Fatshark Predator V2 Vision System
3-Bullet Proof ESC, 900kv Tiger Motors, Graupner 9X5 Propellers
4-4500Mah 4S battery
5-Turnigy 9XR with Frsky Module…"
"Thank you very much Mr. Hattori for the warm welcome and supportive information. I will comply the rules and regulations as stated. Since there is a specific radio transmitter could be used in Japan, i would like to know whether 2.4Ghz frequency is…"
"Hello everyone, i am from diy drones Malaysia, have been active with multirotors since 2011..from APM1.4 oilpan to 2.6. Now i have moved to japan for job attachment for 3.5 years. I have some questions regarding flying multirotors in japan, what are…"
"Sihat..selamat datang ke DIY DRONES MAS.."
"Ooo..sory took me so long to attach u this param. I agree that during the landing sequence it bounce a lot and i have managed to reduce it as i recalibrate the compass via live calibration. and setup RTL landing to 0.0m. i was busy config the…"
"Hello Owen,
This is my setup for AC2.7.3
RTL was nice
AC2.7.3_waypoint_kajang_23092012.param"
This is my setup for AC2.7.3
RTL was nice
AC2.7.3_waypoint_kajang_23092012.param"
"Thanks for ur suggestion, i will add it up soon..Today, i tested waypoints..finally i managed to do waypoints with RTL..for RTL, it worked very well and landed nicely, i set alt (abs) at 5m and did live calibration before take off. i can email u the…"
"@Owen. yea, i agree..to overcome the issue i use ubloc gps, and it has additional battery on the module,within 20-30 seconds it lock the sats,usually 7sats..never reach 12sats so far..if u dont mind,could u share how can i connect additional ubec to…"
"@Owen. Nice video man..i wonder why do u use ubec to power up APM?i never use it, just feed in using esc.."
"@Owen. I have not tested RTL yet but looking forward to. for now i am putting efforts to test for auto landing and way points..if u dont mind,u you share a bit your experience in testing RTL..Thanks bro"
"@Owen..as long as it work, i'm happy with it..thanks anyway..any idea where i could find out on how to set way points?i'm using APM 2.5 with 915Mhz radio telemetry. not sure how it goes.."
"@Owen. Thanks bro..i have managed to make it work..what i did was feed in +12v to minimOSD during firmware and char update..but now i have new issue, i need to reset everytime using it..if not, it only show up this..update char set"
"Hi, a little help here.. i have followed all necessary steps, (using on 5V to feed into MinimOSD) but i coud not see the overlay char, it only showed up booting then with this message...update char...i have updated firmware and char many times, but…"
