Hi all
Is it possible in Arduplane to set the Geofence as it is set in Arducopter so it can be used as a safety feature, to protect against loss of orientation etc as set as always on like it can in copter.
All I can find is a bizzar option where it ha
Read more…hi all
Got a bit of an odd one going on here.
I am trying to configure the Fail-safe option, Mission Planner/Pixhawk does not detect when I turn the radio off so it will not trigger Fail-safe.
If I start mission planner with the radio turned off, it cor
Hi
Need a little help please
In Arducopter v3.3 it says that Auxiliary functions or now supported on Channel 9 to 12.
I have a Ten Channel system connected and although I have enabled option for Channels 9 & 10 they don't work, Channels 1 to 8 work fine
Read more…Hi all
Looking to replace my Pixhawk that died when an ESC went into meltdown and dumped batter voltage up the signal wire and just cannot afford the cost of the genuine items so was looking to the Chinese clones, I then stumbled across these http://w |
Hi all
Just got my first Pixhawk and have a problem
After system boot the status light just flashes yellow, which I understand means its failed its internal systems/safety checks.
Is this a fixable issue or is it an indication the Pixhawk is faulty.
Than
Read more…