I tried to search, but are there any lifting capacity graphs (flight time and battery calculated in) for the 3DR frame withthe 880Kv motors?
If not, what is the lifting capacity with the 880Kv motors and a pretty much standard 3DR frame (I know a sta
Read more…
Hi, I have an EasyStar with the original ArduPilot.
I have done a lot of test's and it flew great in all modes except the auto mode.
In the auto mode it hits every waypoint like it should, but before doing so it circles around and around.
So instead
I have a small problem with the ArduPilot when I put it in both FLY_BY_WIRE_A and FLY_BY_WIRE_B, the rudder goes almost full to the left, not all the way but say 80%.
The rudder still works both ways, and everything else works fine in both the FLY_B
Read more…Hi, I recently bought ArduPilot with an IMU and a shield for my EasyStar.
I have wired it up like the guide on the Google Code page showed.
When I turn it on to test it, I can move the plane an the control surfaces will counter move like they should i
Read more…Hi, I am in the planning face of building an EasyStar with ArduPilot, and I need to buy an transmitter.I have been thinking of buying a Futuba 6EXP, 6EXG or 7C.(Yes, I know about the cheap Turnigy, so now need to mention it.)But which should i go for
Read more…Hi, I am new to this hobby and hope to get some advise here.I am planing on building a DIY drone of course, so i just bought myself an EasyStar kit.After doing some research, this is the setup I am planning to buy for it:Tx/Rx:Futuba 6EXP, 6EXG or 7C
Read more…