I have the APMega running 1.02, Meditaek GPS with latest 1.6 firmware (and a battery), with the HK GCS. The B and C LED's on the APM are lit and the GPS light as well, indicating lock.But the serial output data in the GCS says Fix = 0, Sats = 0, HDOP
I have been following the changes taking place to the ArducopterNG code and was hoping fro a major release some time soon. There doesn't seem to be any visible activity on the Configurator so....
Can someone give us an update as to current development
I have just tried to upload RC1 to a new APM/Oilpan combination and found the only way I could do this was by reverting back to the libraries included with the Zip rather than the latest libraries. It came up with errors in APM_ADC otherwise.
I am trying to test my APMega and have a problem understanding how to get code from the repository. I gather the Zipped up file of libraries is out of date and I should be using the latest from the repository. I look in https://code.google.com/p/ardu
It has been pointed out that the signal output voltage from the EM406A is TTL level, Output voltage level: 0V ~ 2.85V RS-232 level.The input voltage for a ATMega328 is specified as 0.2Vcc for low and 0.6Vcc for high, so operated on 5v it requires max
There are still a number of people who seem to be unable to get the Config Tool to work correctly and are getting the dreaded "Something is wrong" message (I am one of them).I used the serial port sniffer ASP to look at the data going from the Config
I can get the tool to work on a 168 processor Ardupillot but not the 328 version of the Ardupilot.I have not yet managed to write a blank set of data to the EEPROM on the 328 and cannot read anything back either (I get the 'Something is Wrong' messag
In my enthusiasm I loaded the 2.1 Ardupilot software (all seemed to work ok) and then realised I had not proved the servos were being driven in the correct direction using the NE software.I loaded the NE software and it does not work because I think