Hi,
I put "do_jump" into my command list.
Has no effect. Thoughts?
Condition_change_alt and condition_delay also
do not work.
v. 1.2.20.
Also, since I used the Loiter command once,
every time I fly a new mission (even without loiter commands),
when the firs
Read more…Hi,
So happy to find you folks! I've been working on this
project for 6 months, after a successful "regular" balloon launch.
Any comments much appreciated...
My half-ideas are as follows:
In the parameter file, set "Throt_Max" to 0. The RC has
to glide h
Read more…Hi,
My half-ideas are as follows:
In the parameter file, set "Throt_Max" to 0. The RC has
to glide home due to power constraints, until it is visible
to the pilot, who will then switch it to manual and land it.
I don't know how the condition commands wor
Read more…Hi,
Any idea when the Do_Set_Parameter command
is due to be implemented?
Thanks!
--David
Read more…Hi,
Anyone know the current status
of this command? I noticed in
the past there were a few bugs.
When I try using in the sim,
it seems to have no effect at all,
or (once) it had an erratic effect...
Thanks!
--David
Read more…Hi -- I want my plane to be able to dive steeply. So if I set a waypoint at 5000 ft, and another very close by at 2000 ft, it will dive steeply to reach the second point at 2000 ft. What do I need to change in the parameters to make this happen? Than
Read more…Hi,
So when I load the "real" ArduPlane V2.67 firmware, I get a good
gyro lock, the HUD "arms," and I can calibrate my radio.
But when I load the Sim plane firmware (which is what I need
to use right now), the A/C lights flash wildly, the radio
calibratio
Read more…