Hi everyone. Flew for three minutes. Althold loiter worked fine. After that when I switched to either the copter began to ascend. Vibration control is excellent. Any suggestions. Thanks Roman
Read more…Hi everyone, I have an external mag and GPS combo. The problem I have is that the Pixhawk outputs 5 volts over the ic2 connection, the mag takes 3.3. Any simple solution to make this work? Thanks Roman
Read more…Hi everyone, just need some input on the possibility of doing this. Bought, got, 4 brand new rctime 2814 motors. Has four holes for prop adapter. They are spaced too far apart for screw in prop adapter. Tried many already. The motors did come with co
Read more…Need some help everyone to get a decent loiter. Stabilize, Alt Hold work like a charm, In loiter the copter quad wants to fly away. I have done the prearm checks and all is good. Using external compass. Any help appreciated. Thanks Roman
Log attached
u
Read more…I know I saw a post on this earlier but I cannot find it. When connected to Apm 2.5 by radio, the cli just spits through a whole bunch of unintelligible characters over and opver again. Works fine over usb, but not the radio connection. Thanks Roman
Read more…Just wondering if anyone has successfully used the ch 6 tuning function and how the servo points were set up to make it work. Obviously ch 6 on the Apm 2.5, but ch 8, the rotary knob on the DX8. Thanks Roman
Read more…What is the latest version of Mission Planner? Thanks Roman
Read more…Hi everyone, Apm 2.5, running c5 revision beta. I have a older, 6months old large servo gimbal that I still wish to use. Signal wires connected to r10 & r11. Works great. My question, is there a way to center both axis from the mission planner, or do
Read more…When I connected to the cli this is the error that comes up. I did post before, but I can arm the Apm 2.5, but the motors will not spin. Should I do a erase and reload 2.1b? Thanks Roman
Read more…Did a great job of tuning, was working on alt hold and loiter and throttle p. Made a dumb newbie mistake. Decided to calibrate radio. Don't know why. Now APM will arm, but I get no throttle response. The motors will not spin. Tried the motors individ
Read more…Tuning my quad was a challenging experience but a good one. It made me familiar with the settings and if I build another quad or hex or x8 it will so much simpler once we get familiar with what the rates do. A great learning experience. Now for two q
Read more…Trying to get tuning to work on channel six. I have connected aux 3 to ch 6. Aux three is a rotary knob. It works I tested it in tune. However it only works one way. The values go down. Any way to mix so that it would work 50/50. Half way up, half wa
Read more…