Hello.
I'm starting this discussion since there's a lot of confusion and lack of knowledge about PID settings and control theory, so, you can find here a table with several different frames, multycopter types and firmware versions in order to let you
Read more…Hello Michael,
First of all, great job you have been doing with the Planner,
I still keep previous versions in archive and it really progressed a lot, you and your team rock :)
Well, if it's possible, in a future implementation, do you think you can pu
Read more…Hello. I'm having problems with the captured videos of the Planner's HUD. I just can't watch it, the Media Player gives an error as if the necessary codec is not present. Can you tell me if you're using any special codec ? Anyone with this problem ?
Read more…I'm still having the same problem in Mission Planner when I enter the Magnetic Declination in the Planner, if I enter a value "-3.6", "-3,6", etc, the value it assumes will be "-36", so it's not reading the decimal separator. I'm having this problem
Read more…Hi.
I'm having the following problem : When calibrating radio from Mission Planner, if the throtlle is fully down (0 throttle), and I calibrate yaw channel, the motors arm (this is the sequence to do so, but should be desabled while calibrating radio)
Read more…Hello, I've been having some problems with the APM hanging and sometimes with the motors spinning (wich is a pain in the ass when it comes to shut down everything). The board stops responding to RC controls, I can't disarm motors, no responses whatso
Read more…I. I'm having dificulties connecting via USB to the planner (fly mode). COM port well configured. This is happening in version 1.0.47 and 1.0.40 I don't know if it's from the planner or the software version (2.0.37 beta). Also, when I make quad firmw
Read more…Hello everybody. I've noticed some of you have some doubts on wich frequencies of radio are usable within your country. I've found this table very usefull when in doubt. http://www.futabarc.com/faq/frequency-international.html
Read more…Hello. When configuring for 1st time the Arducopter and uploading firmware, when it gets to the question about sonar and magnetometer, it opens a web browser to a page that shows magnetic declination. (in my case 3.6 west), When I enter the value -3.
Read more…Hi. I've updated today the APM Planner and the latest firmware to my Arducopter. I used to be able to make sensor reading via usb (switch away from servo connectors), and now I'm not. I believe to be something different in Arducopter firmware because
Read more…Hello all. I'm thinking of building a quadcopter using ducted fans. Has anyone tryied it ? Can anyone predict if it's going to be harder to control ? Does anyone knows any pros and cons ? Thank you :)
Read more…Hi all !
My APM was working fine untill I upgraded APM Planner and the new APM code. Now it does not reboot properlly, and it does not send any mavlink data, and in cli mode doesn't boot up. I don't know what happened. I loads the firmware, it erases
Read more…I all. I'm using a Futaba 8ch radio T8UAP wich has several possible modes of configuration. Since I'm a newbie in the matter, I had it configured as "HELI SW1", wich means helicopter swashplate type 1. I configured it like this because the Arducopter
Read more…