Article: http://fortune.com/2015/10/21/government-public-drone-registration/
Link to submit your comments: http://www.regulations.gov/#!docketDetail;D=FAA-2015-4378
More discussion:
https://www.reddit.com/r/Multicopter/comments/3prtrr/the_dot_is_asking
Hi all -
I'm having a little trouble determining exactly what happened here. I was doing some initial backyard low-altitude hover testing of my new Y6B. This is a large 750 size sky-hero frame with 6S batts.
Around log line 113630, one arm droppe
Read more…Hi
I had a frightening occurrence today where my 250-sized pixhawk / 3.2 quad suddenly started behaving very erratically in loiter mode -- rapidly gaining altitude.
After spending some time graphing dataflash logs, It seems that the issue began with an
Read more…I just upgraded my printer to a dual extruder, with the ultimate goal of printing vibration-isolating mounts with a combination of ABS and ninjaflex. Apparently ninjaflex adheres to ABS well. The photo above is my first dual extruder project -- it
Read more…Has anyone seen or used this frame?
http://www.rcdude.com/servlet/the-2474/Danger-Den-Skeeter-FPV/Detail
I'm tempted to pick one up, but it only shows up on this one website.
Read more…Hi all -
Took my newly-completed quad outside today for it's first outdoor hover testing.. It's been working perfectly indoors (tethered) for tuning and setup.
Everything started out fine, GPS lock, telemetry ok, armed successfully in stabilize mode
Read more…