We are providing the proper voltage supply to the main board (right around 7.5V), yet the port where we supply voltage to the XBee on the plane is only outputting 0.5V. Any ideas why? The board is soldered properly.
Read more…
We ahve succesfully loaded the code to the ardustation and our buad rates match. When we power the station with an adequate voltage source the LCD screen does not give a readout even when we checked and it is recieveing power through our female pin
Read more…I am attempting to load the code to a Sparkfun main board, no shield (we have one but are in the middle of trouble shooting some issues). The load time took several minutes and at the end I received the following error:
avrdude: stk500_paged_write()
Read more…I have checked every debugging item and all are correct/fixed. I am using a PC with Windows 7 and I get the following error when loading the code:
avrdude: ser_send(): write error: sorry no info avail
Any ideas?
Read more…When we hook up a battery to the board, what LED's should light up? When attempting to load the code, what is the order in which the LED's should blink or alternate?
We are having trouble loading the code, and keep getting errors. We have a 3.3V (3
How is it that the ardupilot code doesn't ask you for moments of inertia, mass, aspect ratio, etc.? I have not found where the code asks for these.
We are having issues when attempting to upload the code to the main Ardupilot board. From what we have read it appears to be a hardware issue. All our solders look fine and everything appears to be connected properly. We read that the board can be
Read more…We are working on a senior design project at the University of Arizona Department or Aerospace Engineering. Part of our project utilizes Ardupilot, and we are trying to figure out how to (if its even possible) tune the code to fit a specific airfram
Read more…