Hi guys,
I have two Arducopters and I am planning to create a swarm type communication between them.
Here is my setup:
1) Two similarly constructed Arducopters with APM 2.5+.
2) Both have Telemetry enabled
Questions:
- I want to be able to control both of
Read more…Hi Guys,
I want to know if someone has achieved something like this with the quadcopter 'at a waypoint' before moving to the next waypoint. '0' in the figure below indicates the waypoint and adjacent curves are path the quad circles around this waypoi
Read more…Hi,
I had a horrible indoor crash today after I armed my motors.
I was in stabilize mode, the quad changed direction towards one side and crashed into the wall, broke 2 props, 2 motor shaft bent. I have to check the 20Amp ESC's if they got burnt in the
Read more…Hi,
I am running APM v3.0 on new Arduino HAL version. It compiles and runs all seems good. My settings are:
Visual Studio 2010 on Windows 7
Arducopter v3.0 (from github) for APM 2.5
--
Compiling 'ArduCopter' for 'Arduino Mega 2560 HAL (Apm 2)'
Binary sketc
I am writing this after I experienced the same situation for the second time.
After my forum post yesterday (here), I thought Arducopter 3.0.1 release sounds good. BUT, I made sure it was not my manual mistake, made sure all connections and possibly e
Read more…Hi All,
I had my Arducopter flight, with AC-3.0.1 firmware.
6 Flight Modes set as:
1. Stabilize 2. Stabilize
3. Loiter 4. Loiter
5. Land 6. Land
I was in Loiter mode and suddenly my copter fell like rain from the air (~7 meters high). I was j
Read more…Hi,,
Apparently I am having trouble with Mission Planner settings. The GUI has been updated since v.1.2.57. Does anyone else face this?? The settings are for my Arducopter (v2.9.1b).
1) ISSUE 1: Setting Flight Mode via Mission Planner. Software->Flight
Read more…Hi People,
I was calibrating my radio and here are the found values (via Mission Planner):
I use Turnigy 9X CH9 Transmitter (Mode 2). Can someone tell me if the values are normal? Normal range is 1100 - 1900.
Is there some way to set up the Transmitter
Read more…Hi All,
This is the second TURNIGY TX9 transmitter that I have got into problems!
I am using Turnigy TX9 Transmitter (Mode 1) /8CH Receiver from hobbyking (standard most people get).
- I changed Mode 1 to Mode 2 by swapping pitch and throttle stick spri
Read more…Hi Developers,
In the hope of getting Mission Planner (1.2.59) up and running. Tacking the last traces of errors on 'ArduPilotMega.csproj'. Before posting this, I have read through Dennis Spanongle's post here, though it hasn't helped me at this level
Read more…Hi All,
This is about a few questions that now or later people will ask. About me, I am interested in APM series like most. I think it has done a great job so far. I myself already own a few and have worked in projects with it over the past years.
As m
Read more…Hi,
I found the pinout spreadsheet as in here, but this is for APM 1. Can someone educate me with the pinouts corresponding to APM 2.5.
I would like to know where are the (free) UART pins on this board???
Thanks,
Shyam
Read more…