So, the manual I have states a solid green LED means that the two radios are connected to each other. On Mission planner, i've gone ahead and done the radio setup as well, and it's confirmed that its saved the two settings on both of the radios.
Howev
Read more…Our High Altitude Balloon (HAB) project aims to return the electronics on board a HAB autonomously. Traditionally, weather and HAB's return electronics safely to the ground via parachute, but this obviously steers waaaayy off from the launch site and
Read more…I'm new to Arduplane, but is it possible to have an aircraft be a pure glider (no motor)? How would I set it up to work this way?
I'll be sending a high altitude balloon up to film the eclipse this monday, and I want to return the cameras via glider,
Read more…So, my motors do not get any signal at all. They just "beep" to signify no signal being received. If i hook them up to my receiver they can calibrate, work, etc just fine.
Currently I have the positive and negative ends removed and only hook up the si
Read more…