Todd's Discussions (23)

Sort by

Tarot 650 Project & complete kit for sale

This is my first attempt at my own build after flying Phantoms & a custom machine built by Aerobot.

Its 90-95% built bet never flown. As it is my first build I would recommend that a full check of everything would be required first. I make no guarante

Read more…

Solo Features

Hi, just wondering whether some of the features of the Solo will be available in I software update for the rest of the community? Or those with original Pixhawk?For exampleThe pause featureCable CamOrbitSelfieThanks in advance

Read more…

Diagnose Motor / ESC issue on new build

Hi,

Working on my 1st build from scratch (Tarot 650 Sport) with Pixhawk running latest Arducopter. Esc's are hobbwing x rotor.

Ive fired her up for the 1st time & it appears that one motor is very slow to respond & at low throttle doesn't spin at all.

A

Read more…

Longer Legs

Hi,

I have a custom quad & need to extend the legs just a fraction as when I land on a soft surface, my gimbal can't level as its touching the ground.

My machine is at its weight level so i really just want to have the same but a little longer.

I can't

Read more…

Fire Go Pro

Hi,

Is it possible to make a GoPro take a picture or start recording video mid air either through a command on Mission Planner or flicking a switch on my tx?

Thanks in advance

Read more…

Fire off a GoPro

Is there a way to fire off the GoPro from the tx or even better change the mode, whilst on the air?Or at worst is this possible from mission planner while flying manually.Thanks in advanceTodd

Read more…

Review Mission

Hi,

Just flew my first missions after upgrading to 1.3.10. Come home & downloaded missions via usb. When i go into telemetry logs load log, there is nothing in the folder where all my logs used to be. If i go to mission planner/logs i can see the kHz,

Read more…

Landing Skid

Hi,

Looking at getting my first retractable landing skids & was wondering what happens if say RTL was fired, would they automatically go to the downward position?

Is there a parameter anywhere that could make skids go down below a certain altitude?

Than

Read more…