Hi,
Does anyone know of a connector that converts from the DF13 (1.25 mm pitch) connector, Like on the APM, to a regular bread board (2.54 pitch) connector? I would like to use the larger connector so I can build a wiring harness for my FPV airplane.
T
Read more…Hi,
I did a first flight with my 3DR telemetry radio a few days ago. I only flew a distance from home of about 0.4 km and I think I am getting a very weak signal. I am using the stock antenna and the default settings (64 airspeed) I attached a graph o
Read more…Hi,
I am having trouble getting my signal lost/ throttle failsafe working correctly and hope someone can help me out.
The hardware: Turnigy 9XR radio tx, APM 2.5, Spectrum AR8000 rx, Turnigy dlux 40A SBEC speed controller.
My understanding of the theor
Read more…Hi,
I see similar problems reported but have not found my answer.
With my setup I am powering the camera, OSD board stage 2, and the video TX separately but with the same 12 V battery. I have red lights on both stages of the OSD board (that's a good th
Read more…HI,
Please look at the attached photo and tell me if I have my Ardupilot power wired correctly. I have the voltage regular wired to the PM connector. The BEC is wired into the output rails. I have removed the JP1 jumper.
Am I missing something? I don'
Read more…HI,
Can you point me to a discussion to set up my DX7i for the APM 2.5? How do you set up for manual flaps and use the 3 position switch to set flight modes. I would not like to use the knob (aux2) to set flight modes.
Thanks in advance.
Tom
Read more…