I suppose the PX4 with its IO kit has analogue ports to receive signals from the current and voltage sensor.
I looked in the wikis for info on this without success. Only info available referred to APM-boards.
Please, can anybody confirm that there is
Read more…Hi, I have been searching for info on some WP parameters, without success (wiki not updated and no mouse-over helptext).
Can anybody please explain how to use the following parameters:
Hi, I have some questions.
1. What is Hit Rad, the column header in MP waypoint table?
2. What is the parameter WP_MODE (and what values are relevant?)
3. What is the parameter WP_MUST_INDEX (and what values are relevant?)
Thanks / Tomas
Read more…I have been using the AttoPilot 90A sensor on my 3DR quad copter, from the start. It works, even though AC firmware requires some software lines to define calibration ratios (I looking forward to that to be set in the Mission Planner configuration).
A
Read more…The log browsing feature is indispensable. And so is the graphing feature.
BUT, there is one thing I really miss, or did not understand how to achieve:
The possibility to graph any combination of parameters simultaneously, while automatically scaling t
Read more…I have been using the AttoPilot 90A sensor on my 3DR quad copter, from the start. It works, even though AC firmware requires some software lines to define calibration ratios (I looking forward to that to be set in the Mission Planner configuration).
A
Read more…
New Altitude control mode for ArduCopter.
Suggestions by Tomas Soedergren
In the current Altitude hold mode available on the AC (when writing this I refer to FW 2.0.55), sonar sensor activated, there are scenarios where the copter response on sonar sig
Read more…I started out with a hexa kit from a spanish supplier. 950kV motors and 9x5 props. Pretty lightweight frame, approx 1,7 kg. Plenty of thrust for climb performance, or stopping a rapid descend. Unfortunately this copter got hit by a flag pole in my ba
Read more…I noticed that when I cut the throttle the motors stop very quickly. And when the propellers are still (while power is on) and I hit them with the finger they does not spin any turns (like when power is off).
This leads me to think the ESC has breakin
Read more…I looked around in the wikis and forums but I could not find updated info on this matter.
Can somebody please help me to sort out the use of parameters Throttle Rate and Altitude Hold?
I also wonder about Acro Roll and Acro Pitch - are they at all used
Read more…Hi guys,
I am struggling with my first ArduCopter hexa project and right now I feel a litte down-hearted about my progress (lack of).
I have been able to fly it decently in Stabilize mode, but it´s oscillating in roll axis so there is definitely some
Read more…This is a copy from a Ground Stations thread where a user reporded unable to enter anything into the parameter fields in the battery tab.
- I experience exactly the same problem!
Though I am currently using Mission Planner 1.0.82 and APM fw 2.0.49.
I ca
Read more…I am currently putting together my first Arducopter hexa and as I am going through the manual wikis I am slowly realizing that everything might not be fully updated to reflect status of current hardware and firmware.
Reading the instruction it seemed
Read more…