Hey guys, so after 9 months I finally got my large quad in the air. I changed ESC's from afro 30a to Hobbywing 40a. I went 40a just because. Anyway, I am running a pixhawk on a x650f frame that has been stretched. I am using 4114 330KV motors with 15
Hey guys So I have been away for almost a year at this point and now I am back. I downloaded the GCS (mission planner) update and also updated the FW in my pixhawk. I was curious on what all changed? Was hoping that you guys would be able to give me
Hey guys I am trying to find the best folding props for my quad. I am using 4114 330kv motors. I got some cheap plastics on there right now. I got them originally just to get me by until I could find something that performed better. I am looking for
I am being told that my problem with my quad lies within the control loops of the flight controller. That being said I am not able to fly my quad to tune it. So where do you start with tuning. Before I lengthened my arms and up'd my motor size from 2
Hey guys I need a bit of help here. I am getting really frustrated. I can get the quad to lift off the ground. It requires constant input on my part to keep it from hitting something really hard. It will roll all of the sudden at almost a 45 degree a
First I want to say that I hope I put this in the right category. Second this is not something I am going to do right away. Its probably going to be 6 months before I put this into action. Just planning now so I can get a good design down and get eve
Title says it all. I want to upgrade the antenna on my M8N Module. Can anyone recommend an antenna around the $100 mark. I am looking to reduce multipath interference while increasing positioning accuracy.
Hey guys ive been doing alot of reading about ardupilot and the pixhawk the past couple weeks and have alot of questions. Most i am answering through searches but, i wanted to ask this one in the forums.What all can you do with a companion like a ras
Hey guys so I got a small issue going on. Its a big inconvenience more than anything. If I connect the battery first my gps powers up but never gets a lock. And this only happens if I leave dont fly the thing for a few hours.
So a little background information first. I just switched from librepilot had a revolution board, I work for months trying to get GPS working on that flight controller, was unable despite all the help from the developers on the forums and such. So, I
Quick question for you guys. I have been trying to get rid of the inconsistent compass message for a couple days now. I am new to the Pixhawk came from librepilot, so I am learning. Anyway I had to mount my pixhawk sideways. So in relation to the fro
Hey guys I spent the night last night trying to get the HC-05 bt module with no success. Baud rate got changed through AT commands to 57600 I also changed its name to Ardupilot to match the GCS. Its connected to pixhawk through Telemetry 1. I can pai
Hey guys Ive decided to finally do it. Im done! Ive been trying for almost 4 months now to get gps working on a revolution board with librepilot! So I cannot afford the pixracer or pixhawk at the moment. sunk to much money into trying to get the revo
I wasn't sure where to put this as far as category but, I need a recommendation I am wanting to replace my CC3D Revolution on my 550 with something APM. So I am needing a recommendation from you guys. These are the things I am wanting.
Whats up guys. So when i first got into quads i did very little research on flight controller and ended up picking the revolution fc. I have three of them now. One on my 550 quad and one on my 250 size quad. So far the have been performong fine altho