Brand new sealed unused:
1. Xbee Pro 868 RPSMA - 20 USD
2. Xbee Pro 868 Wire Antenna - 20 USD 3. Xbee Pro 2.4 RPSMA - 20 USD 4. Xbee Pro 2.4 Wire Antenna 20 USD
Everything for 70 USD
Else refer to individual prices.
Paypal plus fees.
I understand that since the release of Arduplane 2.33, one may:
"ask for any stream rate that is a multiple of 20ms"
Does that mean that I may request all the telemetry data(attitudes, raw sensor, PWN in and PWM out, airspeed etc) to be stream Read more…
Am i right to say that the GPS on the pre-soldered daughterboard with GPS cannot be disabled?
I have looked through the codes in brief.. it seems like there are no codes that provides detection of GPS in the event that an external GPS is conne Read more…
Is there any way to disable the GPS on the daughterboard(without desoldering or changing the daughterboard), and still connect an external GPS and have APM 2.0 use that instead?
Has anyone encountered such a problem before? Every once in a while when I fly my UAV, it flies with a steady state error (parallel along the designated flight path, but about 30metres away from it). It doesnt even appear to be trying to cor
Just a simple question.
Can loiter speed be tuned? (Assuming that the loiter radius is large enough for the maenuveur to be made)
Does it take reference from airspeed and cruise throttle settings?
Im not sure if this problem is due to arduplane 2.27 or mission planner..
somehow when i retrieve the flight logs from APM(converted to .kmz) and open them in Google Earth, the flight paths are all there.... but there is no altitude data at all. Its
May I know where I can obtain the HIL Simulator source code other than downloading directly from Mission Planner? Would like to make some additions to the code before uploading to APM. Tried to look for it in the git branches but I couldnt fi
I've faced a couple of issues with Arduplane 2.27, hope to find some answers here.
Uploading Arduplane 2.27 from Mission Planner works perfectly for me.
But, uploading Arduplane 2.27 from Arduino IDE does not work (APM does not initialize aft
Recently I've switched over from flying a Bixler to a Skywalker.
The skywalker param file available is entirely not suitable for my skywalker plane(think its because of the large differnce in servo throws). Tuning was a bitch.
Also, it is obvi