OK, I got my shiny new APM2 purple board on Tuesday. I powered it up with the microUSB cable, installed 2.1a and everything checks out. Easiest Out-Of-Box experience ever. I can't find Arducopter APM2 docs yet, but I found the ArduPlane wiki now h
Read more…I just downloaded the newest Mission Planner 1.1.4 to see what changed. I see after enabling the sonar we can now choose our model. I have the MB1260, but when I choose it (or any of the other options) from the pull down list I get the following er
Read more…I've wiped my board (reset APM to default), then reprogrammed 2.0.55. I have the compass and sonar, along with an XBee 900 pro for telemetry. Removed the XBee, no change. Removed sonar, no change.
The compass constantly reads in an endless loop of
Read more…I've been flying very close to my TX while I get the hang of AC2, now I'm trying to configure failsafes so I can go a little further without the threat of falling out of the sky.
My setup is a quad, AC 2.0.50 with Optima7 RX and Aurora 9 TX, APM2580+O
Read more…Pardon the cross post, I put this under XBEE troubleshooting but no hits there.
My setup is XBee Pro 900 digimesh, from the PC running MP 1.0.82 I get "loading params", followed by the error message below. "System.Exception: Missed ID expecting 0 go
Read more…I think I have the XBEE modems communicating correctly (I think), but i get the error below from APM on connect. Connect, shows getting Params, then the error message below. And yes the CLI switch is in flight position.
I'd appreciate any advice o
Read more…I've got an APM, Oilpan and GPS and Rusty's BQ-2 frame and am looking to build it out. The DIYdrones store has been out of stock on the motors and ESC's for a while. I inquired with customer service and got a reply that "as we're developing new pro
Read more…