Hi Guys
I want a quality Gimbal, i'm sure i'm not alone. I use an X8 carboncore with a Pixhawk but am reluctant to pay £2000 for a Z15 that isn't even integrated into my controller of choice.
As per the title,Does anyone know if 3DR are working on mar
Read more…Hi Guys
What if any routine do you follow to prolong the health of your expensive brushless motors. I have only read of one person saying that he oils his bearings initially and then regularly afterwards.
Read more…Hi All
Hope someone can help.
This was the second flight of the day, was range testing my video downlink with a new legal power transmitter. First flight all good.
Second flight went like this. Take of , all good and fly away straight line for about 150
Read more…I am familiar with ROI on my flying craft but have no experience at all or knowledge of the ground vehicle firmware.
It appears from the APMRover page that this is not possible, but i believed it is/was.
Would someone please enlighten me as it would be
Read more…Hi Guys
I have a project, as indicated above, to track a high altitude object.
It appears to be feasible to use a gimbal inverted and set the ROI altitude to a large value. I have not yet discovered what the variable range allows. Mission planner lets
Read more…Hi Guys
I want to try this new device rather than buy another 3dr leah 6.
What i want to be able to buy is a complete package ready to go, is this available in the u.k or Europe does anyone know.
Regards
keith
Read more…Hi Guys
Is there a routine that allows a user to fly a manual mission, tracing it in software such that the movement can be re-run as a mission later?
Read more…I am trying to visualise which props i need for a new x8 configuration i want to build
To me it does not seem correct to run props in "reverse" yet the Gemfan props i am used to can only be mounted one way up. Am i suffering only from a lack of the ab
Read more…I have tried numerous times to swap the above 2 settings in mission planner such that pitch is on channel 2.
Mission planner says its 2 and roll = 1 but even after a radio cal it is still wrong.
I have graupner mx16
3DR pixhawk
1.3.7 mission planner
3.2
Read more…Hi Guys
The next instalment of questions from a newbie.
my HUD in mission planner shows failsafe and will not allow me to alter flight modes. It will arm via the safety switch and responds, apparently correctly to throttle input.
Clearly it is not happy
Read more…Hi Guys
Version 3.2 firmware is supposed to have this i understand but i cannot see anything in the Github repository i was pointed to.
No sign of release version either yet.
I want to see if this gets me past my Esc calibration issues but it looks lik
Read more…Hi Guys
please forgive this newbie question but i have looked around the forum and not seen an answer.
I took delivery of a pixhawk unit and GPS this week. all discussion talks about using the 5 to 6 pin cable to connect them.
However the Pixhawk has a
Read more…