Hi everyone,
I'm looking to sell my SF03 lightware laser rangefinder sensor. This was the start of a diy lidar setup which never materialized due to a lack of time after being snatched away to a new job.
It has since been sitting on my shelve and I don
Read more…Hi forumites,
I've finished my quadcopter design but have no CNC mill to finish cutting my carbon fibre sheets.
Does anyone know a good, relatively cheap CNC milling service in the greater Boston area if not in Massachusetts?
Any advice is welcome.
Cheer
Read more…Hi all,
I was annoyed by the fact that the standard debian package of the APM planner 2 does not install nicely on Ubuntu 14.04 because of the upgraded openscenegraph99 libraries (which mess up dependencies).
As such I changed the control file on the d
Read more…Hi everyone,
I was just setting up my new APM 2 copter and I noticed that one of my ESC's was running really hot.
Switching some of the signal cables around shifted the problem to the newly connected ESC. This rules out a defect in the ESC and so the i
Read more…Hi all,
I recently ordered an Arducopter kit however, I still need a good radio and battery to make this set complete. However, going through pages of different batteries and having a choice of plenty radios I can't see the forest for the trees. Coul
Read more…