Hi Everyone,
So I have had an Iris for a while now but never set up until yesterday. I loaded the latest firmware using APM planner, everything seemed to have succeeded. Following instructions on Iris page I have not been successful at fully arming I
Read more…Hi Everyone, While connected to APM planner over USB, I keep on getting a 241 cmd error or timeout. Ive tried this atleast 10 times without success. Any guidance would be appreciated. See attached screenshot:
Good Evening Gentlemen,
I just took possession of 1 of 3 Solo Drones and was wondering if there was any future plan to have control over Hero 4 Black edition as it records in 4k and 2k?
I am going to compare to the DJI Phantom 3 professional. Im a 3DR
Read more…My New landing gear made from 7075 aluminum alloy
Read more…Guys,My quad keeps on flying to one side, on the mission planner all the sensors seem to be working fine. I did noticed I have a bent motor shaft will that cause this behavior?And if so, are there any solid shafts out there that won't bend as often (
Read more…Hi Guys,
As the tittle says, my quad keeps on flipping over after i let off the throttle a bit. its flying in stabilise mode.
another problem i have is that it powers up extremely fast(spools props), on the attached video throttle was set at about 5-10
Read more…Hi Guys,
has anyone thought of a better landing gear for the arducopter, as i just broke mine and 3dr are out of stock. it was easier when i brake a propeller and just run to the store and pick up 8. Any input would be greatly appreciated.
also i rece
Read more…Hi guys,
had a question on what size props for my quadcopter (arducopter from 3d robtics). i have the 2212-13-A-BP Brushless Outrunner Motor with 9x4.7 apc props. i feel that these props might be to small for my quad, but not sure. here's a link on th
Read more…hi guys,
just as the tittle says, i have a turnigy quadcoter. with a hobbyking kk2 board. i am having issues getting to fly it, arms three of the four motors power up and fourth one only powers up when move the right joy stick forward. dont know if i
Read more…This is what I have so far;Cheeta motors20A ESCTurnigy talon frameHobby king controller boardTurnigy cobtrol with receiver3cell lipoThis is the first time building one lets see how it goes, tommorow I will solder a wire harness and hopefully fly it v
Read more…Hi Guys,
I need a parts list for a quadcopter just to get started, remote, boards, etc. this is going on to turnigy talon Quadcopter from hobby king. i dont want to get into autopilots untill i can control the quad remotely. im more of a fixed wing an
Read more…Hey Ladies and gents,
I am new on here and want to learn the basics on autonomous flight. i want to purchase an arduplane that is not fully assembled( want to learn how to put together myself). Also laws and local ordinances here in california. i supp
Read more…