My y6B seems to be surging or dropping momentarily and I am now seeing the following PM Fail Message
Size (kb) 2035.5966796875 No of lines 27255 Duration 0:01:54 Vehicletype ArduCopter Firmware Version V3.2.1 Firmware Hash 36b405fb Hardware Type Free Mem 0 S
I am looking for a case to protect my Canon S110 while the lens is extended and it is taking pictures. I have lucked out with not damaging the sensor so far and using a 3d printed mount that has the camera attach directly to a Y6 frame, but fear when
I am looking to try some aerial mapping with a 3DR Y6B. The Y6B has a pixhawk flight controller and I am looking for the appropriate way to connect to a chdk Canon Sx260. I have found this link which is a cable I can make right now in house.
My control is through a spektrum ar6100 with signal lines to the input of the APM. I have it setup per the apm wiki in the futaba order (Aileron, Elev, Throttle, Rudder, etc). When I power on the APM the ESC makes the tri tone I am used to on a arduc
In setting up arduplane on an APM 2.5 board that will go in a skywalker 1900, I notice that I do not have the ARM Disarm function that I am used to with the arducopters.
I start off in Manual mode on the controller and immediately the prop will spin
I purchased an arducopter presoldered and tested kit from Fah Pah electronics during the first order group and am attempting to set it up over vacation. This will be my first time building a hobby kit and I have a few questions about the elec
