• Male
  • QLD
  • Australia

Anthony's Groups

Anthony's Discussions

FrSky ASS-70 Airspeed Sensor

Started Jan 18, 2017 0 Replies

Would this air speed sensor be able to be used with pixhawk…Continue

Not enough power to get off ground

Started this discussion. Last reply by Anthony Feb 10, 2013. 1 Reply

I have changed from a kk2 board to the ardupilot with the latest firmware done al the calibrations but do not have enough power to get off the ground The quad had plenty of power when using the kk2…Continue

Simulation of heli in xplane

Started this discussion. Last reply by Anthony Jan 29, 2013. 1 Reply

Is it possible to run a simulation in xplane with the simheli firmware.I have run the planesim firmware in xplane no problem, just wondering about running the helisim in xplane10The wiki only…Continue

Pos hold flight mode unknown

Started this discussion. Last reply by OlivierD. Jan 24, 2013. 7 Replies

Can not change to pos hold mode if I save the mode in any of the 6 positions in flight planner and swich to it I get mode unkowen on the flight data screen all other modes work fine.using a quad with…Continue


Anthony's Page

Profile Information

About Me:
New to uav's rc pilot for many years.
Please tell us a bit about your UAV interest
new to uav's Rc pilot

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones


© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service