Doug Hunsaker
  • Male
  • Provo, UT
  • United States
Share

Doug Hunsaker's Friends

  • Andrew Murphy
  • HyperGuy
  • Craig Elder
  • Joshua Johnson
  • Jerry Giant
  • Julian
 

Doug Hunsaker's Page

Profile Information

Please tell us a bit about your UAV interest
I've designed several UAVs and currently enjoy developing UAV design tools.
Hometown:
Provo

Doug Hunsaker's Photos

  • Add Photos
  • View All

Doug Hunsaker's Blog

MachUp Drone Design Software Goes Global

Posted on December 16, 2015 at 7:30am 0 Comments

We are happy to announce that users from around the world can now access MachUp, the world's easiest drone design software.



Designers from any country (except those on the US sanctions list) may use the software for aerodynamic development of non-prohibited airframes. See the full software terms here.



When you're ready to start, log in…

Continue

Short Course on Mission-Specific Aircraft Design

Posted on October 7, 2015 at 7:30am 10 Comments

Hey guys,



Sam Weiss and I have put together a short, 30 minute course on designing aircraft for specific missions. Would you mind watching these three 10-minute videos and leaving some feedback? We're looking specifically for comments and suggestions of what areas within aircraft design are not well understood or are the most…

Continue

How to avoid pitfalls when using taper and twist

Posted on September 29, 2015 at 8:30pm 7 Comments

Hey guys,

Just put together a quick video to show the effects of taper ratio and twist and how they interact. Turns out using rules of thumb in this area can be detrimental. I have used similar rules of thumb in the past, but thought it was high time to walk through some rigorous calculations to see what's best.

Hope it's…

Continue

Why sweep hurts endurance and what to do about it

Posted on September 24, 2015 at 2:00pm 19 Comments

Hey guys,

I just wrapped up a project that taught me a lot about the effects of sweep on flying wings. Turns out sweep can significantly increase drag and hurt endurance. Sweep isn't all bad, though. There are ways to make a flying wing stable if you do it right.

I put together this film to explain the physics of what's going on and how to get stability without sacrificing endurance.

Hope it's helpful.…

Continue

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones

 
 
 

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service