Ezra Zygmuntowicz
  • Male
  • Portland, OR
  • United States
  • Blog Posts (3)
  • Discussions
  • Groups
  • Photos
  • Photo Albums
  • Videos

Ezra Zygmuntowicz's Friends

  • arashi

Ezra Zygmuntowicz's Page

Profile Information

About Me:
I'm a self taught computer scientist and entrepreneur. Started a company called http://engineyard.com and worked there for 4 years but now I work for VMWare.
Please tell us a bit about your UAV interest
I had an ar-drone that was pretty fun but I flew it onto a roof and was unable to recover it. So I ordered an arducopter quad kit that will be showing up in about a week.
Portland or

Ezra Zygmuntowicz's Blog

New 3D Robotics frame build of my ArduCopter

Posted on October 1, 2011 at 4:30am 3 Comments

I had a fully tricked out with every options ArducopterMega I purchased fully assembled from jdrones last year. I usually assemble all my own stuff so it figures that I crashed it *hard* on the first or second flight and basically destroyed the frame. This sent me down the rabbit hole and since then I have built 8 multi-rotors by hand including a few quads, a Y4, a Y6 a…


Another warning to take your props off when you are tuning a new copter (KK control board)

Posted on September 25, 2011 at 7:00pm 0 Comments

cut myself pretty good l;art night on a new hexacopter I just finished. I even had the props off while I tuned the ESC's and the KK control board gyros. Then I put the props on and did one test inside where I held the middle of the copter and had it take off while I held it just to make sure it was all good. My wife got home right while I was doing this and I looked away for a…


Sub $100 quadcopter I designed and 3d printed last night in 6 hours...

Posted on September 25, 2011 at 7:00pm 3 Comments

Sub $100 quad copter *
motors $7.99 x 4 =…

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones


© 2020   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service