Jeff P
  • Male
  • Trumbull, CT
  • United States

Jeff P's Friends

  • Nathan Douglas Lindeman
  • Dan Murray
  • Drew Cook
  • Ronny Grimm
  • David Dewey
  • Bernt Christian Egeland
  • Hugues
  • MarvinS
  • Kirk D
  • Tim McPherson
  • leonardthall
  • Marco Robustini
  • Gary McCray
  • Andrew Tridgell
  • Michael Oborne

Jeff P's Groups

  • X8


    278 members

Jeff P's Discussions

LIDAR Lite question

Started this discussion. Last reply by Jeff P Apr 11, 2015. 1 Reply

Hello,  I have my Lidar lite hooked up PWM to my plane (using Pixhawk).  Small issue, getting readings but at its lowest point, when belly of plane is on ground (I have Lidar mounted under wing), it…Continue

Tarot Ironman1000 PID Help on 3.1

Started this discussion. Last reply by Søren Møller Dath Mar 27, 2014. 1 Reply

 I am picking up an Tarot Ironman 1000.  I currrently have a 960 and 650 Tarot and PID tuning was fine.  I just got the PID's close and then ran an Autotune.  Does anyone have some general PID's for…Continue


Started this discussion. Last reply by Jeff P Dec 29, 2013. 3 Replies

Hoping someone can help, I have a lot of knowledge of APM 2.0, 2.5, 2.6 do not need the basics.Never had a problem with APM.  Received my Pixhawk yesterday.  Please note I have tried…Continue


Started this discussion. Last reply by Mihai Nov 21, 2013. 3 Replies

Hello, i currently use a BEC to power my 2.6 HexaI also still utilize the 3 dr power module .. I remove the red wire so no additional power flows into the board. The issue is that when I run a…Continue


Jeff P's Page

Profile Information

About Me:
Flying 3D helis for 2 years, been flying my two quads for about one year.
Please tell us a bit about your UAV interest
Interested in UAV, I have spent a few years learning to fly first, now I am ready to get into UAV's. And a little AP.

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones



Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service