Joe Breznai
  • Male
  • Buffalo, WY
  • United States

Joe Breznai's Friends

  • Johann van de Venter
  • Christopher Stephens
  • Amos Olson
  • Rod
  • Charles lakins
  • Per Kristian Haga
  • Randy

Joe Breznai's Groups

Joe Breznai's Discussions

Bat-Amp-Prevolt Question

Started Feb 17, 2015 0 Replies

Sorry may have posted in wrong section-"Ground Stations". Re Posting her as it's MP question Using MP 1.3.19 Build 1.1.5508.10848 and the Bat-Amp-Prevolt is sets to:18.0018, not the 17 as specified…Continue

RTL Motor shutdown, high wind.

Started this discussion. Last reply by Joe Breznai Feb 24, 2014. 4 Replies

All has been going well since  I did Autotune earlier this week. When flying my Quad 2 days ago in High winds ;20mph, gusting to 26mph , all was going well until the last RTL. I was ABOVE RTL…Continue

Tags: motor

Wiring question

Started this discussion. Last reply by R. D. Starwalt Aug 8, 2013. 2 Replies

I have had 2 separate cases where the cable failed to the GPS. Once as a result of a hard landing (crash) that broke my CD mounting plate, the other from an rebuild, where I was just unplugging and…Continue

Tags: Wire, GPs


Joe Breznai's Page

Profile Information

About Me:
Flying RC since 1970. Brand new to multicopter. Have built many Radios, receivers, servos, back in the day ( when my eyesight was a bitt better)in the 70's and 80's. I go back to Heathkits, Ace, Royal Receivers, Kraft, ProLine, and had my first Futaba radio when they were a new thing. Fly planes and dabbled with helicopters and pre-built multicopters. Don't remember when I last purchased a pre built PC, but beyond learning the basics of BASIC am not a programmer. My favorite programming language is solder!
Please tell us a bit about your UAV interest
General hobby use, I just like the idea of automatic stabilization and autonomous flight, a dream when I started into RC. Hell, when I started a good day was 3 flights without a crash!
Buffalo, Wyoming ( A transplant from North East Ohio )

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones


© 2020   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service