"@Patrick, I am interested of FlirOne with Rasberry Pi 3 for Aerial Thermal Photo Mapping. Can the FlirOne be trigger with USB cable? Or this is doable with Rasberry Pi Linux? The idea is to trigger FLirOne using USB cable attached to Pixhawk FC. The…"
"@Bill, you have SEEK Thermal camera trigger for Pixhawk? Does it means that you interface this SEEK thermal camera using MAVROS or Mavlink and use the telemery port of Pixhawk? I am very interested to buy a camera from you if I could geotagged the…"
"I would be good to see some documentation on which firmware to download and flash SOLO firmware with the new firmware that support the new Drotek RTK. I like see Wiki or documentation how to install a new firmware from Drokek (if possible) for SOLO…"
I think this device does not working with 3DR Solo since it does NOT have RDF telemetry (e.g. 433Mhz and 915Mhz as shown your the photos of the 2 RDF antenna).
3DR SOLO works on WiFi (2.4 Mhz frequency)."
Open source advocate. Strategic Planning Manager at APRIL - FibreOne (Technical Services, Strategic Planning Department) Riau, Sumatra, Indonesia at the moment.
Please tell us a bit about your UAV interest
Customising open source UAV hardware and software for aerial photography for natural resource management (e.g. forestry plantation, agriculture, mining,etc.) as well for mapping application for natural calamities (typhoon, earthquakes, etc.)
No comments yet!
You need to be a member of DIY Drones to add comments!