Paul Pridday
  • Male
  • Detroit Lakes, MN
  • United States
Share

Paul Pridday's Friends

  • elad orbach
  • Grips
  • Mario bernard
  • Darren
  • tshado

Paul Pridday's Groups

 

Paul Pridday's Page

Profile Information

About Me:
Heli guy getting into quad flight
Please tell us a bit about your UAV interest
Quad flight with possible FPV interests
Hometown:
Detroit Lakes

Comment Wall (3 comments)

At 9:38am on April 25, 2012, Mario bernard said…

Hi paul,. the wiring is exactly the same as on the arducam wiki..http://code.google.com/p/arducam-osd/wiki/How_to_start_minim

but i used the SECOND diagram...wich bypasses the 12 volts to the board and feeds the camera and lawmate directly . The board is feed via the APM (5v). to do so , you need to solder the 2 stages jumpers as shown in the wiki.  If you want, you can skype me and i can assist you and do some troubleshooting. My nick is mbern11  or look for Mario Bernard  in Richelieu Quebec,   Canada...    it will bemuch faster then chatting in this forum.  Regards

At 11:07am on April 25, 2012, Mario bernard said…

Paul, dont forget, if you solder these jumpers, use 5v APM feed ONLY, and not the 12 v feeding the video and camera, otherwise you ll frie the board...

At 6:19am on April 26, 2012, Paul Pridday said…

I got it finally last night.  I had a hell of a time getting one of the jumpers to bridge.  I actually ended up using a small piece of wire to bridge it. 

One thing I did was check the cabling coming out of the Lawmate Tx.  There are two leads and one of them outputs 12V and the other is 5V.  Very dangerous when hooking up to a MinimOSD.  Thanks for the heads up on that!!

 

Paul

You need to be a member of DIY Drones to add comments!

Join DIY Drones

 
 
 

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2018   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service