Pete Burnight
  • Male
  • Santa Cruz, CA
  • United States
Share
  • Blog Posts (6)
  • Discussions
  • Groups
  • Photos
  • Photo Albums
  • Videos

Pete Burnight's Friends

  • Sarel P. Wagner
  • Jesus
 

Pete Burnight's Page

Profile Information

Please tell us a bit about your UAV interest
www.photopete.com

Pete Burnight's Blog

Drive 10 Servos using only 2 Arduino Pins

Posted on November 28, 2010 at 7:30pm 9 Comments





I've been building both AutoPilots, and QuadraCopters, and I wanted to drive more servos and ESCs, with less jitter, so I used some ideas from the Paparazzi gang and developed a way to drive up to 10 servos with just 2 output pins from an Arduino or ATMega8.



The design uses just one chip, a Johnson style Decade Counter, and requires only two output pins from the Arduino. The Arduino uses one PWM pin (pin9), and one general IO pin (pin8). All the pulse… Continue

I2c GPS frees up Serial Port

Posted on October 8, 2009 at 12:00pm 16 Comments

I wanted two way communication with my airplane, and had moved the serial communication stuff to a 2nd arduino (see my prev blog) but I didn't like the way the code looked, so I reconfigured the system to have the 2nd Arduino handle the GPS and Gyro, and then use I2c to send the data to the main processor. Essentially making the GPS into an I2c device, and freeing up the main serial port for 2-way com with the ground.…



Continue

2nd Arduino adds 2-way Com with Ground

Posted on October 6, 2009 at 10:46am 5 Comments

I wanted two way communication with my aircraft, but when the GPS is running, the Arduino board only has 1 side of its single serial port available, so I added another Arduino Mini to provide 2-way communication between my ground station and the aircraft.



The additional board consists of a 5 volt Arduino Mini Pro, with a ATMega 328 chip running at 16 mHz, and a Spark Fun 5 volt carrier board for the XBee. That's it. I had to move my Gyro to this new board, cause I used I2c to link… Continue

Adding Gyro Smooths out Turns

Posted on October 4, 2009 at 12:30pm 5 Comments

While flight testing my Magpie and ArduPilot, I was having a problem with over-shoot during Way Point Navigation. After hitting the way point, the aircraft would start turning towards the next way point, and then continue turning until way past the bearing to the next way point, requiring the aircraft to make a sweeping s-turn to get back on track towards the next way point.…



Continue

Easy to Build Ground Station

Posted on October 3, 2009 at 2:04pm 2 Comments

I've been tuning the GPS portion of my ArduPilot / Magpie airframe combination, and put together this flight data recorder to save the results of the flights without having to take a laptop out to the field.





The data recorder consists of a Spark Fun Data Recorder, an XBee radio modem, and a battery. The Data Recorder takes a serial stream at 9600… Continue

Comment Wall (1 comment)

At 12:16pm on October 16, 2009,
Developer
Mark Colwell
said…
Thanks for the update. I was just reading your original ArduinoSlave.pde code.
I want to connect ArduIMU as a slave to extract u-blox GPS data & DCM data and send to ArduPilot, but this may tax system too much, I will just try..

You need to be a member of DIY Drones to add comments!

Join DIY Drones

 
 
 

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service