Raph
  • Male
  • Whitestone, NY
  • United States
Share

Raph's Friends

  • Joe Dietrich
  • Yanjun Zhang
  • isboset amador
  • Dustin
  • Jean-Marie PRIGENT
  • BluSky1
  • Chris Austin
  • J Dilling
  • Euan Ramsay
  • Peter Spero
  • Lito P
  • leonardthall
  • Manfred Dickgiesser
  • Joakim M
  • Wessie

Raph's Groups

Raph's Discussions

Yard sale! Long Range Y6 BNF or PARTS- Upgraded components - everything must go!

Started Jun 4, 2017 0 Replies

Hello, Have a 3DR Y6 BNF for sale, get it as a kit bind & fly or cannibalize it - cheaper together in you can pickup in NYC area, or 'a la carte'. Sad but it must go! A lot of fun to build and…Continue

Pixhawk & Analog Airspeed sensor

Started this discussion. Last reply by Ben Oct 28, 2015. 4 Replies

Hello,I'm helping someone install an analog airspeed sensor with the pixhawk, the wiki says:The “airspeed” pin 15 is located on a 3 pin DF13 connector on the Pixhawk board.This pin can take voltages…Continue

APM 2.6 - AP3.2.3 - Spiral of death in FBWA

Started this discussion. Last reply by G Jan 17, 2017. 19 Replies

Hi Everyone, Very weird crash today. I have 12-15 flights all flawless before this incident. When it occurred I immediately thought I lost a servo - but upon inspection both servos were fine.…Continue

AC 3.2 + EKF & Flying indoors

Started this discussion. Last reply by Raph Jan 31, 2015. 3 Replies

Hi Everyone!I've been tasked with shooting some video indoors. Through the 3.2 beta thread I remember there being a few mentions that GPS data is used when EKF is enabled even when not in GPS modes.I…Continue

 

Raph's Page

Profile Information

Please tell us a bit about your UAV interest
love to build and fly!

Raph's Photos

  • Add Photos
  • View All

Raph's Videos

  • Add Videos
  • View All

Raph's Blog

Mako Flying wing + Arduplane 3.3

Posted on June 18, 2015 at 7:30am 8 Comments

Been having a lot of fun with the Mako wing & Arduplane (APM), here's a short video of the build & some FPV flying. Really happy to see Tridge keep APM support in 3.3!

Params: mako autotune params

High res images of…

Continue

Comment Wall (1 comment)

At 10:50am on February 2, 2015, Joe Dietrich said…

I will have to connect my gimbal later today and see what my PIDs are... 

I pretty much followed this guy's video:

http://www.rockberry.pk/yt/watch/pkEEBEzGJCk

I bumped my Pitch "POWER" setting from 90 to 125, and the gimbal seems to work nicely at these values.

You need to be a member of DIY Drones to add comments!

Join DIY Drones

 
 
 

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service