Rod
  • Male
  • Ballarat, VIC
  • Australia
Share
  • Blog Posts
  • Discussions (1)
  • Groups
  • Photos
  • Photo Albums
  • Videos

Rod's Discussions

Question regarding onboard signal processing functionality

Started this discussion. Last reply by Chris Anderson Oct 9, 2011. 1 Reply

Quick/simple/dumb question, that will expose my newcomer status:Does the IMU shield board perform any on-board processing of the sensor data (e.g. filtering, calibration, etc), or is it just…Continue

 

Rod's Page

Profile Information

About Me:
New here
Please tell us a bit about your UAV interest
Lots to learn

Comment Wall (1 comment)

At 1:51pm on March 16, 2012, Tom Low said…

Hi there Rod.    You commented that you got the DIY rembzibi OSD to work.  I still get "Failed: OSD did not respond" error when I try <Start Test> in the Serial Cable Setup tab.   (I am using the DIY drones FTDI cable connecting to (TX,RX,5V,GND) on the board, and following "Programming Mode Instructions" sequence (holding down SW1 and letting go after plugging in).     Do you have any suggestions for what I am doing wrong?   (I considered powering up the board with 5V, hitting RESET, and THEN plugging in the FTDI, but if you have a sequence that works, I'd be grateful to know exactly what it is.  (BTW, I also have Sparkfun's FTDI board, as well as others, so I could adapt if you didn't use the DIY FTDI cable).

Thanks in advance for any comments.   Best,   Tom 

You need to be a member of DIY Drones to add comments!

Join DIY Drones

 
 
 

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service