Tarik Agcayazi
  • Male
  • Fairfax, VA
  • United States

Tarik Agcayazi's Discussions

Radios connect to each other (LED's solid), but cant connect on the computer? *resolved*

Started Dec 19, 2017 0 Replies

So, the manual I have states a solid green LED means that the two radios are connected to each other. On Mission planner, i've gone ahead and done the radio setup as well, and it's confirmed that its…Continue

Project log: Autonomously returning a glider from the stratosphere!

Started this discussion. Last reply by Tarik Agcayazi Oct 10, 2017. 4 Replies

Our High Altitude Balloon (HAB) project aims to return the electronics on board a HAB autonomously. Traditionally, weather and HAB's return electronics safely to the ground via parachute, but this…Continue

Tags: wing, Flying

Pure glider on ArduPlane?

Started Aug 17, 2017 0 Replies

I'm new to Arduplane, but is it possible to have an aircraft be a pure glider (no motor)? How would I set it up to work this way? I'll be sending a high altitude balloon up to film the eclipse this…Continue

Wiring issues?

Started Aug 15, 2017 0 Replies

So, my motors do not get any signal at all. They just "beep" to signify no signal being received. If i hook them up to my receiver they can calibrate, work, etc just fine.Currently I have the…Continue


Tarik Agcayazi's Page

Profile Information

About Me:
Self-proclaimed aerodynamicist
Please tell us a bit about your UAV interest
More leaning on the design of the aircraft rather than the computer science aspect.
Fairfax, VA

Tarik Agcayazi's Blog

Project Log 6: Returning an autonomous glider from the stratosphere | Building a Flight Controller 2

Posted on July 25, 2018 at 3:30pm 2 Comments

On the sixth installment of my project log, I finally get some test flights off with the flight controller i started to make from an arduino 101.

Up until this point, we barely had the aircraft gliding. This week I decided to add some methods, and cruicial parts to the aircraft that make it behave more like an actual aircraft, and…


Project log: Autonomously returning a glider from the stratosphere!

Posted on October 10, 2017 at 12:39pm 10 Comments

Our High Altitude Balloon (HAB) project aims to return the electronics on board a weather balloon autonomously instead of drifting away on a parachute. My Project Log series aims to provide short sweet and to the point updates to said project. Heres the most recent one:

Heres some background:

Our High Altitude Balloon (HAB) project…


Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones



Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service