Tom Fey
  • Male
  • Arlington Heights, IL
  • United States
Share
  • Blog Posts
  • Discussions (3)
  • Groups
  • Photos
  • Photo Albums
  • Videos

Tom Fey's Friends

  • Bob Bray
  • Laurie Videle
  • Luca Mariotti

Tom Fey's Discussions

1945 Kiekhaefer 0-45-1 runs

Started Sep 15, 2015 0 Replies

I just completed my 1945 Kiekhaefer 0-45-1 engine (747 cc, 20-22 hp, 35 lbs) restoration to ground running status only. It was used in the Radioplane TDD-3/OQ-14 aerial gunnery target (137.5 inch…Continue

Tags: TDD-3, OQ-14, 0-45-1, Kiekhaefer, drone

1943 Righter 2-GS-17 gunnery drone engine runs

Started this discussion. Last reply by Tom Fey Aug 25, 2013. 2 Replies

After a year of restoration, Righter 2-GS-17, #42-2250 runs. Six hp @ 3800 rpm, 277 cc, 2 cylinder, 2 stroke, 26 in. diameter contra-props, approx. 25 lbs weight, retrofitted motorcycle dual coil on…Continue

Tags: engine, Righter

 

Tom Fey's Page

Profile Information

About Me:
drug research pharmacologist, electric r/c aircraft prototyper, student of WWII aircraft technology, member aircraft engine historical society
Please tell us a bit about your UAV interest
righter aircraft engines
Hometown:
Arlington Hts., Il. USA, suburb of Chicago

Comment Wall (2 comments)

At 11:16am on August 22, 2013, Luca Mariotti said…

Hi Tom,

nice work but you need to follow exactly the starting procuderes as illustrated by the manual, I also see a fuel leakage from the carburettor (I believe), with such engines is better to avoid it and ALWAYS have a fire extinguisher on hand! Anyway is a very good works. Recently we have restored a 0-15-03 and we have tested it.

Regards

Luca

 

At 1:23pm on September 14, 2015, Carl Swanson said…

Hi Tom,

I am helping my brother-in-law get his Righter 2-GS-17 running.  It started, but backfired quite badly.  We tried adjusting the timing, but still couldn't get it to smooth out at all.  I am now thinking the points were set way too wide.  What did you gap yours at?  I think we also need to replace the condenser, as I am seeing a bit of spark at the points when they open.  Any advice would be appreciated.  Thanks, Carl

You need to be a member of DIY Drones to add comments!

Join DIY Drones

 
 
 

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service